MAN#650258
1994-96 Chevy Caprice & 94-95 Impala
Dakota Digital Gauge Installation
This sheet covers the installation of the Dakota Digital gauge kit into the original cluster.
1. Remove the cluster from the vehicle.
2. Remove the 8 screws holding the clear lens onto
the cluster. Remove clear lens, lens to separator
adapter and separator plate from the gauge cluster. You will not reuse the separator plate.
3. Remove outer gauges and the gear indicator/speed
display cover.
4. Remove the 4 screws holding in the speed display
board. Also remove the 5 light bulbs in the main
display area.
5. Cut out the divider between the slots on top of the cluster as marked with a red X in the photo on the
left. Remove any sharp points or edges as the ribbon cable for the new gauge system will pass through
here.
6. Pass the ribbon cable through the opening as shown. Feed it through until the display panel is close to
position.
Summary of Contents for RET
Page 13: ...650066 11 ...
