MAN# 650369
STATUS AND WARNING INDICATORS
The high beam, turn signals, low oil, and neutral indicators are powered by
the gauge and are activated by the stock wiring harness.
Several indicators are supplied on the stock wiring harness. Some of
these may not be active on your motorcycle. These include the security (red key
symbol), engine (red ‘E’), ABS (red ‘ABS’), low fuel (amber fuel pump symbol), and
cruise control (green arrow and circle symbol).
LOW VOLTAGE WARNING
When the voltage drops below the warning limit with the engine running,
“LO” and your current voltage will be displayed. (default warning limit is 11.0V)
SPEEDOMETER
The speedometer is read from the engine control module (ECM) data bus.
This can be calibrated to allow for differences in tires or gearing. Calibration is
discussed in a later section.
TACHOMETER
The tachometer is read from the ECM data bus.
The bar displays rpm x1000 with a range of 350 – 7000 rpm. The rpm can also optionally be shown on the
message display.
CLOCK
The clock uses a 12 hour format and can be set by pressing and holding the switch while the clock is displayed.
After the switch is held for a few seconds the hours will begin flashing. Momentarily pressing the switch will change the
hours, holding the switch will move to the minute set and the minutes will begin flashing. Momentarily pressing the switch
will now change the minutes. Holding the switch will exit the clock set mode.
GAUGE SETUP AND CALIBRATION
The setup menus are entered by holding the switch in while turning the key on. The menus are as follows:
Menu
Description
dIag
(
EngInE
,
seCURE
,
ABS
,
DONE
)
read diagnostic codes
ADJvST
(
FASTER
,
SLOWER
)
(
75
-
125
)
adjust calibrate speed
vnIt
(MPH, km/h )
select speed unit
S SET
(
OFF
,
500
-
7500
)
miles to service setting
PERF
(
ON
,
OFF
)
turn on/off performance displays
Lights
(
On
,
OFF
)
turn on/off left, right, high, oil, neutral gauge face indicators
NIGHT
(
ON
,
OFF
)
turn on/off automatic night dimming
UPDATE
(
1
,
2
,
3
)
set digital rpm update rate
WXARN
RPM
(shown on bar graph)
set rpm shift warning point
COLOR
RPM
(shown on bar graph)
select rpm bar graph color, red or green
WXARN
V
(
9.0
-
12.1
)
set low volt warning point
WXARN
P
(
LO 5
-
36
) (
HI
50
-
300
)
set pressure warning points
SET FC
(
HEAD F
,
HEAD C
,
400F
,
200C
,
302F
,
151C
)
select temperature sensor and unit
HI F-C
(
200F
-
420F
or
93C
-
215C
)
set temperature warning point
GEAR
(
DONE
,
PRESET
,
LEARN
)
transmission gear display selection
FUEL
(
DONE
,
TEST
,
RESET
,
ADJUST
)
low fuel light setup
Range
(
ON
,
OFF
)
Enable distance to empty reading
(
done
,
Sender
,
rESET
)
Reset initial range learn or setup fuel gauge
INFO
display gauge revision code on speedometer
odoMK-
one-time odometer preset
E
A
B
MPH
km/h
N
RPM
ABS
0
1
2
3
4
5
6
7
V
P
