Manual # 650566
3. Connect one end of the
interconnect harness to the new
HDX speed gauge as well as the
Buzzer (optional for audio
feedback).
Buzzer Connector
2. For each gauge opening, cut three pieces of the
supplied foam tape,
2” long. Install foam strips on
the top and sides of each opening about ½” down
from the face of the housing. This foam provides
a cushion where the new HDX cans are installed
and forms a tight, rattle-free fit.
4. Route the other ends of the interconnect harness and the buzzer through the large opening
shown below. Using the two provided
10-
32 x 1.5”
screws and
nylon shoulder washers
,
secure the speedometer assembly to the housing. Start the screws into the back of the factory
housing and into the pull-
block on the back of the gauge assembly. Tighten with a 1/8” Allen
wrench.
Cable routed through
indicator light opening
Foam tape
