Dakota Digital ECD-200BT-1, Quick Start Manual, Page: 6 / 10

MAN# 650704A
6
Dedicated Menu Displays
The following displays in the LED panel will
not have a corresponding speedometer needle
movement. These are in sequence after the

option.
The VSS calibration adjustment is from 75% to 125% of the current calibration value, or +/- 25%.
Calibration menu adjust (0 MPH): - LED:

•
If making a calibration percentage adjustment while using a VSS input (not OBDII), an
adjusted speed will reset the calibrated speed as the new 100% reference point.
•
Tap
the switch until “  ” is shown, then press and hold the switch to select it.
•
Release the switch. The display will show either “  ” (make the speedometer faster) or “  ”
(make the speedometer slower).
•
Tap the switch until the desired direction is shown, then press and hold the switch to select it.
•
The display will show
“  ”. Tap the switch to change the percentage value
•
Press and hold the switch to save it.
•
Tap switch until
“  ” and hold the switch. or turn the key off to exit setup.
Pulses menu display: - LED:

•
Shows the current pulse rate the ECD is set to drive the speedometer.
•
This does not indicate the input VSS.
•
When pressing and releasing the switch to get to

, hold the
switch until “  ”
•
A number will appear,

= 8,000 PPM,

= 8,200 PPM
Input source menu
The ECD-200BT can read a regular electronic vehicle speed signal (VSS) from a dedicated
speed sensor or from a VSS output of an engine computer or transmission computer. It can also
read OBDII speed in 1996 and newer GM and Ford vehicles, and 2003 and newer Chrysler/Jeep
vehicles. It will not be able to read CAN speed from aftermarket ECMs like Holley or FAST, or non
US standard protocols.
Input menu display: - LED:

•
Press and hold the switch, then turn key on
•
Tap switch until

is displayed. Hold switch until
“  ” is displayed
•

= speed input signal will be from a VSS source
o
Press and hold the switch until
“  “ to save and exit to main menu
•

= speed input signal will be from a OBDII source
o
When

is selected by holding the switch until
“  ” appears two options appear
o
 – saves and exits back to main menu
o
 – a submenu of four ODBII channels to pick from, if the ECD conflicts with a scanner
▪

\

\

\

o
Tap the switch to change the ID value
o
Press and hold the switch to
save until “  ” and exit to the main menu