Dakota Digital ECD-200BT-1, Quick Start Manual

Page: 5 / 10

MAN# 650704A
5
Adjust (20 MPH): - LED:
“  ”
•
Needle should be pointing to 20 MPH (32 km/h).
•
Press and hold the switch until the needle drops to 0 MPH. Then release the switch.
•
The needle will move to 15 select to decrease your speed or 25 to increase your speed.
•
Tap the switch to change the selection, press and hold the switch until the needle moves to
zero.
LED: “  ”
•
Release the switch and the needle will now operate normally as you drive.
•
Drive at a constant speed, follow another vehicle, use a GPS, or use some other method to
verify your actual speed.
•
Holding the switch for one second will change the speed by about 1 MPH in the direction
selected. Press and hold the switch to change the speed reading more quickly.
•
If you go past your desired speed, you will have to go back through setup and choose the
other direction, to make a fine adjustment.
•
When no changes have been made for 10 seconds, the new calibration will be saved.
•
If the input is set to
“  , the needle will not move and the LED will display “  ”
Preset (45 MPH): - LED:
“  ”
•
The LED readout will also display along with the needle movements.
•
Needle should be pointing to 45 MPH (72 km/h).
•
Press and hold the switch until the needle drops to 0 MPH
– LED: “  ”
•
Release the switch.
•
The following pulse per mile (PPM) presets are available:
o
10 MPH = 4000 ppm LED:

o
20 MPH = 8000 ppm LED:

o
30 MPH = 16000 ppm LED:

o
40 MPH = 64000 ppm LED:

o
50 MPH = 128000 ppm LED:

o 0 MPH = factory preset LED:

•
Press and release the switch to change the selection press and hold to save.
•
Saving will drop the needle to zero, and show “  ” in the LED display
•
Tap switch until “  ” is displayed, then hold the switch or turn the key off to exit setup.