Manual #650345
To set or change the ID numbers and set orientation:
•
Hold the switch beside the BIM terminal strip while turning the key on. The BIM display will show the current
revision code while this is held.
•
Release the switch. The display will show
ì-C-
”.
•
Press the switch. The BIM display will show “
C-1
”.
•
Release the switch. The display will show the current ID for channel 1.
•
Press and release the switch to change the setting from
1
-
16
or
OFF
.
•
Press and hold the switch to save the setting. The BIM display will show “
-0-
” or “
180
”.
•
Release the switch. This is the heading adjustment to allow the sensor to face forward or backward.
•
Press and release the switch to change the setting.
•
Press and hold the switch to save the setting. The BIM display will show “
-E
” or “
E-
”.
•
Release the switch. This is the flip adjustment to allow the sensor to be mounted right side up or upside down.
•
Press and release the switch to change the setting.
•
Press and hold the switch to save the setting. The BIM will restart with the new settings.
GND PWR
T-
T+
GN
D
PW
R
T-
T+
heading:
-0-
flip:
-E
heading:
-0-
flip:
E-
heading:
180
flip:
-E
heading:
180
flip:
E-
^
FRONT
OF
VEHICLE
^
Label up
Label down
P
W
R
G
N
D
BIM-17-1
COMPASS / TEMP
A
IR
+
A
IR
-
I/
O
I/
O
www.dakotadigital.com
605-332-6513
P
W
R
G
N
D
BIM
-1
7-1
CO
MP
AS
S /
T
EM
P
A
IR
+
A
IR
-
I/O
I/O
ww
w.d
ako
ta
dig
ita
l.c
om
te
ch
su
pp
ort
@da
ko
ta
dig
ita
l.c
om
60
5-3
32
-6
51
3
