MAN #650617
BIM-01-2-AEM
Bus Interface Module for AEM Engine Management
setup/status switch
BIM-01-2-AEM
Bridge Module for AEM Systems
www.dakotadigital.com
605-332-6513
INPUT
BIM-xx-2 power & data connectors.
Either one can be used.
+12V
KEY ON POWER
(fused 5 - 20 AMP max)
BIM-xx-2 18 inch power/data harness
BIM-xx-1 adapter harness
BLACK WIRE
RED WIRE
Connect to main
chassis ground
To gauge control box
or BIM-xx-1
Connect directly to
another BIM-xx-2
Connect to the BIM-01-2
if you need to connect to a
BIM-xx-1 or gauge system
Connect to the BIM-01-2
if you need to connect to a
BIM-xx-2
Connect to the
BIM-01-2
4 PIN AEM CAN
connector
AEM adapter harness
This Bus Interface Module is designed to read engine information from specific AEM CAN bus (AEMnet) enabled devices.
These kits include Infinity ECU, Series 2 EMS or EMS-4. The module is connected to the AEM device through the 4-pin
AEMnet connection plug on the main harness.
There are two interface (I/O) ports on the module. Either one can be connected to the gauge system or to another
module, allowing several units to be daisy chained together. Do not connect the I/O port to anything other than a Dakota
Digital gauge or BIM. Do not mount the module in the engine compartment; it should be mounted in interior of the vehicle.
The engine and transmission information that is available from the unit depends on the AEM module programming and
add-ons. The possible values are: engine RPM, vehicle speed, engine coolant temperature, intake/manifold air
temperature, oil pressure, fuel pressure, A/F ratio, MIL, trans temp and boost.
Available readings: engine RPM, vehicle speed, engine coolant temperature, intake/manifold air temperature, oil
pressure, fuel pressure, A/F ratio, MIL, trans temp and boost.
