ARC-1000 rev. A
Air Bag Control System
Introduction
This control system can be connected to a remote transmitter system to allow individual remote
control of the air bag system. The functions include individual corner up/down, all up/down,
front up/down, rear up/down, and timed dump all.
This control system can also be connected to a display module and pressure senders to allow
monitoring and control of all four corners and optional monitoring of the tank pressure. The
functions include four different height presets for automatic up/down control, manual up/down
control, and a pressure controlled bag dump. The bag senders can be either 150 psi units or
400 psi units for high pressure systems. The tank sender is always the 400 psi unit.
IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are
going to be working on or under the vehicle. Failure to do so can result in serious injury if the
system is accidentally activated.
Wiring
Main connector
RED
constant
12V
power
BLACK ground
YELLOW
accessory
power
WHITE/GREEN
right rear down solenoid (not used for FRONT/REAR setup)
GREEN
right rear up solenoid (not used for FRONT/REAR setup)
WHITE/PURPLE
left rear down solenoid
PURPLE
left rear up solenoid
WHTE/ORANGE
right front down solenoid (not used for FRONT/REAR setup)
ORANGE
right front up solenoid (not used for FRONT/REAR setup)
WHITE/BROWN
left front down solenoid
BROWN
left front up solenoid
Display/sender connector
GREEN
right rear pressure sender (not used for FRONT/REAR setup)
PURPLE
left rear pressure sender (rear sender for FRONT/REAR setup)
ORANGE
right front pressure sender (not used for FRONT/REAR setup)
BROWN
left front pressure sender (front sender for FRONT/REAR setup)
GRAY
tank
pressure
sender
GRAY CABLE, RED
to display PWR terminal
GRAY CABLE, BLACK
to display GND terminal
GRAY CABLE, bare wire to display GND terminal (cable shield)
GRAY CABLE, WHITE
to display WHT terminal
GRAY CABLE, GREEN
to display GRN terminal
BLUE
external
remote
input
Remote receiver connector
Mates to ARR-1000 module harness connector
1
