1. Make sure both the
“A”
and
“B”
units are powered on and the
rubber plugs
are inserted into the power button recess.
2.
Use the provided small screws, split ring lock washers and flat washers to
mount the
“A”
and
“B”
beams to the “C” brackets.
3. Align the
“A”
and
“B”
units so the lenses are pointing towards each
other.
4. The beams can be rotated inside the “C” bracket by loosening the screws on
the top and bottom of the sensor to help achieve alignment. After rotating
the sensors re-tighten the screws.
5. If the beams are paired, you will get a signal when you walk between the
beams. If you get a signal every 20 seconds (5 minutes optional), this is the
reminder signal and the beams are not aligned. Slightly reposition the
beams until the reminder stops and the beams are activated by walking
between them.
MOUNTING SENSORS TO THE “C” BRACKET:
M4x10 Screw
Lock Washer
Flat Washer
Loosen Screw To
Rotate Sensor
M4x10 Screw
Lock Washer
Flat Washer
WHEN MOUNTED, THE LEVEL BUBBLE MUST
BE TOWARDS THE TOP
2 screws
2 screws
Mount with
Bubble on Top
