PAIRING THE SENSORS:
NOTE: It is recommended to charge both the “A” and “B” unit via a
USB Micro charger (not included) for about 4-6 hours
before starting the initial set-up.
1. Before mounting the sensors in a permanent location, start by placing
them on a table or other flat surface about 6 to 12 inches apart with
the three IR lenses pointing towards each other.
2. Press and release the power button on the
“B”
sensor. The LED will
start flashing.
3. Press and release the power button on the
“A”
sensor and the LED will
start flashing green.
4. When the LED stops flashing on the
“A”
sensor, the pairing is complete
(about 30 seconds).
5. Test the pairing by completely blocking the beams. A piece of
carboard can be used or physically move the beams so they are not
aligned. The LED on the
“A”
sensor will flash for about two seconds.
USB
Charging Port
BACK
FRONT
IR LENSES
LED Light
Power
Button
Rubber
Plug
Be sure to re-insert rubber plug
before mounting permanently
