• Press and release the POWER button to clear the “ZONE” and “TTL”.
• With the keypad unlocked, press the MODE and UP
key at the same time and
then release.
• While in programming mode, use the DOWN
button to toggle through the
zones (1-16).
• If the display reads “USE”, the zone is occupied by a sensor.
• To delete the sensor from the zone, press and hold the MODE button for 2 seconds.
“DEL” and “COdE CLEArInG” will appear in the screen.
(FIGURE 2)
• Press the MODE and DOWN
button at the same time and release. The display will
now show “ADD” and “COdE LEArnInG” for that zone. You can either
program a sensor to that zone or continue on by pressing the DOWN
button to
move on to the next zone.
8
DELETING (CLEARING) SENSORS FROM THE PR-4000
NOTE:
To exit programming, press and release
the power button.
FIGURE 2