4
5
Installation
Tools needed:
Small Phillips Screwdriver;
Large Phillips Screwdriver; Small Standard Screwdriver.
Set Up:
1. Set PIR, RF Shock Sensor and CAD-03 dipswitches to match.
The first five dipswitches on all units (Figure 1 - 1 and Figure 2 - 1)
need to be set exactly the same with the last 3 dipswitches on
the PIR sensor and RF Shock Sensor set to OFF.
(Note: On the PIR
and shock sensor, “off” is in the down position. On the Dialer, “off” is
in the up position.)
2. Install battery in PIR sensor (Figure 1 - 2) and mount at desired
location.
(Note: recommended to replace batteries every
6 months.)
3. Remove the battery insulator by pulling black tab
from the back of the RF Shock Sensor. Unclip the
bracket from the back and mount in desired location.
Figure 1*
1
2
Figure 2*
1 2 5 4 3
* Pictures shown in white for readability.
CAD-03 Kit Manual.indd 4
10/15/2009 10:16:01 AM
