8
Each depression of the push lever will drive a nail. As soon
as the desired number of nails have been driven, remove
finger from the trigger.
Keep your finger off the trigger except during fastening
operation, because serious injury could result if the push
lever accidentally contacts you or others in work area.
Keep hands and body away from the discharge area.
This tool may bounce from the recoil of driving a fastener
and unwanted subsequent fastener may be driven,
possibly causing injury.
Some types of loaded nails can spark out of the muzzle
during a anil driving operation.
WARNING
FIG. 19
If all warnings and instructions are followed, safe
operation is possible with all two system: SINGLE
1.
ACTUATION MECHANISM and CONTACT ACTUATION
MECHANISM.
Always handle nails and package carefully. If nails are
dropped, collating plastic may be broken.
After nailing:
1). Disconnect air hose form the tool.
2). Remove all nails from the tool.
2.
3.
COLD WEATHER OPERATION
When using the tool in cold conditions the tool will cycle
slower than usual while driving the first nails. The cycle rate
will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.
DO NOT USE A FROZEN TOOL.
Allow tool to thaw before
using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool
damage.
ADJUSTING THE NAILING DEPTH
Disconnect the tool from the air source before making
adjustments.
Such precautionary safety measures reduce
the risk or unintentional tool operation.
Disconnect tool from air supply.
Remove nails from the tool.
Adjust tool driving depth:
To reduce the nail depth , turn the adjustment knob
counter clockwise (FIG 20).
To drive the nail deeper, turn the adjustment knob
clockwise (FIG 21).
Reload nails as described in the "Loading Nails" section
of this manual.
Reconnect air supply.
1.
2.
3.
4.
5.
WARNING
WARNING
Too Deep
Flush
Turn the adjustment knob counter clockwise
FIG. 20
Flush
Too Shallow
FIG. 21
Depth of Drive
Adjustment
Depth of Drive
Adjustment
1.Set the switching device to the downward position.
2.Pull the trigger with the tool off the workpiece.
3.Depress the push lever against the workpiece to drive
a nail.
4.Move the tool along the workpiece with a bouncing
motion.
3). Supply 5-10 drops lubricant into the air plug on the
tool; and open the petcock on the air compressor tank to
drain any moisture.
USING THE NO-MAR TIP
When attaching or detaching the No-Mar Tip, be sure to
remove your finger from the trigger and disconnect the air
house from the nailer.
WARNING
Switch Button
1
Upward position
Trigger
3
2
Turn the adjustment knob clockwise
FIG. 18
