05
Do not exceed maximum recommended air pressure
marked on the tool. Verify prior to using the tool that the air
source has been adjusted within the rated air-pressure
range. Be sure the air pressure gauge is operating properly
and check it at least twice a day. Tools operated in excess of
their maximum pressure rating may operate abnormally or
burst resulting in personal injury.
To connect the tool to the compressor only use pneumatic
air hoses that meet the following criteria:
CONNECT THE AIR SUPPLY:
Snap the air hose onto the quick connector.
Check for air leakage. If leakage is noted, stop using the
tool and perform repair by qualified personnel
immediately .
Be sure the air pressure gauge is operating properly and
check it at least twice a day.
Minimum hose pressure rating, 200PSI.
Minimum hose inner diameter, 1/4 in.
Maximum hose length, 100 ft.
1.
2.
3.
NAIL LOADING
FIG. 4
WARNING
Connecting the air supply after loading nails reduces the
risk of unintentionally driving a nail and injuring yourself or
someone else.
Connect air supply.
Pull the pusher back to the end of magazine. Lock
pusher in the place by lock button. Then pull the
magazine side shelter back.
Place full clip of desired fasteners into magazine from
the side. Up to 100 cleat nails can be loaded into
magazine. Be noted that, when holding the L cleat nails,
the side with the L head should be in the left of the
magazine side shelter. Press the lock button, then the
pusher set back to make the magazine side shelter down
back.
1.
2.
3.
FIG. 6
FIG. 7
LOADING CLEAT NAILS
LOADING STAPLES
Connect air supply.
Pull the pusher back to the end of magazine. Lock
pusher in the place by lock button. Then pull the
magazine side shelter back.
Place a full clip of 1/2"Crown Staples in the magazine
from the top. Up to 2 x 45pcs to 2 x 60pcs can be loaded
into the tool.
Press the lock button, then the pusher sets back to make
the magazine side shelter down back.
1.
2.
3.
4.
Pusher
Lock button
Staple
Magazine
side shelter
T cleat
Lock button
Pusher
Magazine
side shelter
L cleat
FIG. 5
CONNECTING AIR SUPPLY
Never use oxygen or other bottled gases as a power source.
Explosion may occur. Combustible gases and other bottled
gases are dangerous and may cause the tool to explode.
Never connect the tool to an air source that is capable of
producing air pressure exceeding 200PSI. Excessive
pressure can cause abnormal operation or cause the tool to
burst, resulting in personal injury.
WARNING
WARNING
WARNING
www.chinaairtool.com
MODEL:06A-618BR
