27
GB
Introduction
The remote control:
• 2 keys: for ON (ARMED) and OFF control,
• 4 keys: for ON (ARMED), OFF, Partial 1 and Panic
alarm.
All keys can be programmed to function as a user requi-
res.
Preparation
• All the remote control keys are factory-configured to
issue the following commands:
If factory programming is not suitable, refer to the
Configuration section.
Programming
Programming enables the remote control to be recognised
by the control panel.
To programme the remote control, the control panel must
be in installation mode. If this is not the case, press:
Programming sequence
3
2
OFF
Armed
Indicator lamp
OFF
Armed
Partial 1
Panic
Alarm
master code
engineer installer code
✱
)
)
)
)
)
then
10 s max.
1)
Press
*
then
#
on the keypad
built into the
control panel.
2)
Press and hold
the
“OFF”
key until
the control panel
responds.
3)
The control panel
confirms remote control
programming
with a voice message.
“beep, remote control X”
then
Summary of Contents for 612-21X
Page 32: ...32 ...
Page 36: ...803402 G 03 06 ...
