DAITEM 145-21X, Installation Manual, Page: 13 / 19

GB
78
1. Put DIP switch 1 in the ON
position.
2. Close the detector cover.
3. Switch the control panel to
test mode:
4. Check the area of detection
using the indicator LED and
adjust the detector if need be.
With each detection the
control panel issues the voice
message “Beep, deterrence
detector X” (depending on the
configuration).
5. Switch the control panel back
to installation mode, press:
6. Reopen the cover, to put DIP
switch 1 to OFF.
Close the detector cover and
tighten the locking screw.
8. Operating test
8.1 Detection zone test
1. Switch the control panel to
user mode:
2. Put your control panel in Total
Arm mode.
3. Wait for the exit time delay.
4. Cross over the protected area
and check that the control
panel responds (see your
control panel’s installation
manual).
8.2 Real test
The control panel takes battery
faults, anti-tamper faults and
radio faults on the detector into
account.
Battery fault
Following a system command,
the control panel issues the
following voice message: “beep,
fault, battery, detector X” .
Anti-tamper fault
Following a system command,
the control panel issues the
following voice message: “beep,
fault, anti-tamper, detector X” .
Radio fault
Following a system command,
the control panel issues the
following voice message: “beep,
fault, radio, detector X” .
9. Maintenance
9.1 Fault indication
1. Switch the control panel to
installation mode and ask the
master user to press:
then press:
2. Open the case of the detector
(see § Opening the detector).
3. Replace the used lithium
batery.
9.2 Changing the battery
IMPORTANT: the detector’s
configuration is saved when the
battery is changed.
IMPORTANT: the test button makes it possible to chec k if the battery
is OK. The indicator on the radio board lights red when the button
is pressed.
master code
engineer
installer code
engineer
installer code
engineer
installer code
engineer
installer code