Installation of Back Housing onto Junction Box
Installation Guide
2
1
2
3
4
5
Disconnect power to
the junction box
Remove the junction box
cover plate
For proper installation into
a dual gang junction box, the
tabs between adjacent back
housings must be removed.
Carefully observe the correct
orientation (the UP arrow
should be in the upper right
corner on each back housing).
After double checking the
product orientation, break off
the necessary tabs using pliers.
Uninstall existing wall
switches from the junction
box.
DOUBLE CHECK PRODUCT ORIENTATION BEFORE BREAKING OFF TABS.
The wall dimmer will only install into the back housing in one orientation.
Break off tabs only after the correct product orientation has been confirmed.
6
Install the back housing(s)
of the wall dimmer(s) into
the wall box.
Daintree® Wireless Controls
Wireless Scene Switch(WWD2-4IW)
Terminate wires (previously
connected to wall switch)
with wire nuts.
