www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
ARCH048 (Rev 04/02/2021)
Lumination
®
(Tetra
®
Contour)
Installation Guide
This product is intended to be used as a lamp control gear that is installed after the mains control switch.
Conforms to the following standards:
LED Driver Installation
To LED system
Output wires
Green with
yellow
stripe
(ground)
AC line
White (neutral)
Black (line)
To LED system
Output wires
Green with
yellow
stripe
(ground)
AC line
White (neutral)
Black (line)
To LED system
Output wires
Green with
yellow
stripe
(ground)
AC line
White (neutral)
Black (line)
Min
Typical
Max
Input Voltage (VAC)
90
100-277
305
Input Frequency (Hz)
-
50/60
-
Input Current (A)
0.7
-
2.5
Output Voltage (VDC)
23.25
24.0
24.75
Output Current (ADC)
-
-
3.8
Output Power (W)
-
-
180
Environmental Operating Temperature Range
-40°C
+25°C
+60°C
Environmental Humidity (non-condensing)
0%
-
90%
Environmental Storage Temperature Range
-40°C
-
+85°C
Enclosure Specification
IP54: Dry or damp location rated
Dimensions
15.5 in. x 2.5 in. x 1.6 in. (392 mm x 62 mm x 40 mm)
Mount LED driver and remove
junction box cover. Carefully
remove knockout for AC line
input wires. Install appropriate
electrical fittings in the knockout
holes for wire protection.
1
Connect the supply wire
that is attached to your LED
system to the red (+) and
black (-) output wires of the
LED driver as outlined in the
“Electrical Connections”
section of your LED system’s
Installation Instructions.
2
Connect the AC line to the black
(line) and white (neutral) input
wires of the LED driver using
18-14 AWG (0.82-2.08 mm
2
)
twist-on wire connectors.
Ground LED driver by connecting
green wire with yellow stripe
to grounding screw. Replace
junction box cover.
3
Technical Specifications
Note:
For remote mounting or loading information refer to the LED System Installation Instructions.
