9
1
Press the operation mode selector button
several times and select “ ” (program dry
operation).
2
Press the ON/OFF button of the user interface.
The operation lamp lights up and the system
starts operating.
3
Press the air flow direction adjust button
(only for double-flow, multi-flow, corner,
ceiling-suspended and wall-mounted). Refer
to “
6.3 Adjusting the air flow direction
”.
Stopping the system
4
Press the ON/OFF button of the user
interface once again. The operation lamp
goes off and the system stops operating.
NOTICE
Do not turn off power immediately after the
unit stops, but wait for at least 5 minutes.
6.3
Adjusting the air flow direction
For BRC1C62
1,2
1
Press the air flow direction button to select
the air direction.
The air flow flap display swings as
shown right and the air flow
direction continuously varies.
(Automatic swing setting)
2
Press the air flow direction adjust
button to select the air direction of
your choice.
The air flow flap display stops
swinging and the air flow direction
is fixed.
(Fixed air flow direction setting)
For BRC1E62
1
Press air flow setting button
• To select air volume or direction setting,
press “
” buttons.
• With direction selected,
using the “
” buttons.
Movement of the air flow flap
Double-flow+multi-flow units
Corner units
Ceiling-suspended units
Wall-mounted units
For the following conditions, a microcomputer
controls the air flow direction which may be
different from the display.
COOLING
HEATING
• When the room temperature is
lower than the set
temperature.
• When starting operation.
• When the room temperature is
higher than the set temperature.
• At defrost operation.
• When operating continuously at horizontal air flow direction.
• When continuous operation with downward air flow is performed
at the time of cooling with a ceiling-suspended or a wall-mounted
unit, the microcomputer may control the flow direction, and then
the user interface indication will also change.
The air flow direction can be adjusted in one of the
following ways:
• The air flow flap itself adjusts its position.
• The air flow direction can be fixed by the user.
Automatic “
” or desired position “
” .
01_EN_3P344160-11V.indd 9
08-Oct-20 9:22:56 AM
