Daikin VRV IV RKXYQ5T8Y1B Series, Installer And User Reference Manual

Page: 107 / 156

19 | Configuration
Installer and user reference guide
107
R R8T7V1B
VRV IV heat pump for indoor installation
4P499898-1A – 2020.10
19 Configuration
In this chapter
19.1 Overview: Configuration......................................................................................................................................................... 107
19.2 Making field settings............................................................................................................................................................... 107
19.2.1
About making field settings ................................................................................................................................... 107
19.2.2 To access the field setting components ................................................................................................................ 108
19.2.3 Field setting components....................................................................................................................................... 108
19.2.4 To access mode 1 or 2............................................................................................................................................ 110
19.2.5 To use mode 1 (and default situation) .................................................................................................................. 111
19.2.6 To use mode 2........................................................................................................................................................ 113
19.2.7 Mode 1 (and default situation): Monitoring settings............................................................................................ 114
19.2.8 Mode 2: Field settings............................................................................................................................................ 118
19.2.9 To connect the PC configurator to the compressor unit ...................................................................................... 122
19.3 Energy saving and optimum operation.................................................................................................................................. 122
19.3.1
Available main operation methods........................................................................................................................ 123
19.3.2 Available comfort settings ..................................................................................................................................... 124
19.3.3 Example: Automatic mode during cooling ............................................................................................................ 126
19.3.4 Example: Automatic mode during heating............................................................................................................ 127
19.1 Overview: Configuration
This chapter describes what you have to do and know to configure the system after
it is installed.
It contains information about:
▪ Making field settings
▪ Energy saving and optimum operation
INFORMATION
It is important that all information in this chapter is read sequentially by the installer
and that the system is configured as applicable.
DANGER: RISK OF ELECTROCUTION
19.2 Making field settings
19.2.1 About making field settings
To configure the heat pump system, you must give input to the compressor unit's
main PCB (A1P). This involves the following field setting components:
▪ Push buttons to give input to the PCB
▪ A display to read feedback from the PCB
▪ DIP switches (only change the factory settings if you install a cool/heat selector
switch).
Field settings are defined by their mode, setting and value. Example: [2‑8]=4.