21
E
ngl
ish
ON TIMER Operation
■
To use ON TIMER operation
• Check that the clock is correct. If not, set the clock to the
present time. (page 8.)
1. Press
.
• “
” and setting time are displayed on the LCD.
• “
” is displayed on the LCD.
• “
” blinks.
2. Press
until the time setting reaches
the point you like.
• Each pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press
again.
• The TIMER lamp lights up.
■
To cancel ON TIMER operation
4. Press
.
• “
” and setting time disappear from the LCD.
• “
” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
■
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
NOTE
■
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
Displa
y
01_EN_3P248442-3.fm Page 21 Tuesday, September 8, 2009 1:54 PM
