28
Trouble Shooting
These cases are not troubles.
The following cases are not air conditioner troubles but have some reasons. You may just continue using it.
Case
Explanation
Operation does not start soon.
When ON/OFF button was pressed soon after
•
operation was stopped.
When the mode was reselected.
•
This is to protect the air conditioner.
•
You should wait for about 3 minutes.
Hot air does not
fl
ow out soon after the
start of heating operation.
The air conditioner is warming up. You should wait for 1 to 4 minutes.
•
(The system is designed to start discharging air only after it has reached a certain
temperature.)
The heating operation stops suddenly
and a
fl
owing sound is heard.
The system is taking away the frost on the outdoor unit.
•
You should wait for about 4 to 12 minutes.
The outdoor unit emits water or steam.
In HEAT mode
The frost on the outdoor unit melts into water or steam when the air conditioner is in
•
defrost operation.
In COOL or DRY mode
Moisture in the air condenses into water on the cool surface of outdoor unit piping and
•
drips.
Mist comes out of the indoor unit.
This happens when the air in the room is cooled into mist by the cold air
fl
ow
during cooling operation.
This is because the air in the room is cooled by the heat exchanger and
becomes mist during defrost operation.
The indoor unit gives out odour.
This happens when smells of the room, furniture, or cigarettes are absorbed
into the unit and discharged with the air
fl
ow.
(If this happens, we recommend you to have the indoor unit washed by a
technician. Consult the service shop where you bought the air conditioner.)
The outdoor fan rotates while the air
conditioner is not in operation.
After operation is stopped:
The outdoor fan continues rotating for another 60 seconds for system protection.
•
While the air conditioner is not in operation:
When the outdoor temperature is very high, the outdoor fan starts rotating for system
•
protection.
The operation stopped suddenly.
(OPERATION lamp is on.)
For system protection, the air conditioner may stop operating on a sudden large voltage
•
fl
uctuation.
It automatically resumes operation in about 3 minutes.
No remote controller signals are
displayed.
The remote controller sensitivity is low.
The display is low in contrast or blacked
out.
The display runs out of control.
The batteries are dying and the remote controller is malfunctioning. Replace all the
•
batteries with new size batteries, AAA.LR03 (alkaline). For details, refer to “To set the
batteries” of this manual.
Page 8
01_EN_3P232717-2C.indd 28
01_EN_3P232717-2C.indd 28
12/22/2008 3:58:09 PM
12/22/2008 3:58:09 PM
