Daikin homecontrols EKRCTRDI2BA, Installer And User Manual

Page: 25 / 40

25
Configuration Configuration
6 Configuration
The configuration of the accessory can be set up complete -
ly in the ONECTA app. For further information on configura -
tion of the accessory without using the DHC Access Point,
see the DHC Application Guide.
The following modes and settings can be adjusted:
6.1 Automatic mode
6.2 Manual mode
6.3 Offset temperature (not yet available)
6.4 Programming a schedule
6.5 Operating lock (not yet available)
6.6 Holiday mode
6.1 Automatic mode
In automatic mode, the temperature is controlled in accor-
dance with the set schedule. Manual changes are activated
until the next point at which the schedule changes. After-
wards, the defined schedule will be activated again.
6.2 Manual mode
In manual mode, the temperature is controlled in accor-
dance with the current temperature set via the push-but-
tons (D + F) . The temperature remains activated until the
next manual change.
6.3 Offset temperature (not yet available)
As the temperature is measured on the DHC Room
Thermostat, the temperature distribution can vary through-
out a room. To adjust this, a temperature offset of ±3.5 °C
can be set. If a nominal temperature of e.g. 20 °C is set
but the room presents with only 18 °C, an offset of -2.0 °C
needs to be set. An offset temperature of 0.0 °C is set in
the factory settings.
This setting is not yet available in the ONECTA app
and cannot be changed for the moment.
6.4 Programming a schedule
You can create a schedule with time slots for heating and
cooling according to your personal needs. For further infor-
mation, see the DHC Application Guide.