Daikin FXFQ100SVM, Operation Manual

Page: 5 / 8

3P335595-2D English 4
2. Take out the air filter.
Carry out the work in the order mentioned below.
1
2
1 Pull the air filter end inclined downward and unhook
the hooking hole of the air filter from the projection of
the grille. (both right and left)
Air filter Hooking hole Projection
2 Lift the air filter and unhook the hooking hole of the air
filter from the projection at the grille upper part. (both
left and right)
Projection
Air filter
Lift up the air filter
Hooking hole Projection
3. Clean the filter.
Clean the contamination with a vacuum cleaner or wash
it with water.
If the air filter
is extremely
contaminated,
wash it with
neutral detergent
using a soft brush.
After dewatering,
dry the air filter in
the shade.
NOTE
• Do not wash the air filter with water of 50°C or higher.
It may cause decolorization and deformation.
• Do not heat the filter with a fire.
It may cause burning.
4. Attach the air filter.
• Attach the air filter in the reverse order mentioned in
the clause 2.
5. Close the suction grille.
Slowly lift the suction grille, and finally, securely fasten it
to the main body of the decoration panel, while pressing
the two knobs.
NOTE
• The straps may be caught when the suction grille is
closed. Before closing the suction grille, ensure that
the straps are not getting out from the side of the
suction grille.
(Good) (Wrong)
Strap
Suction
grille
Strap is getting
out from the
suction grille.
6. Turn off the indication “ ” or “Time to clean fil ter”
displayed on the remote controller after turning on
the power.
• For remote controller other than BRC1E type,
press the filter sign reset button “ ” on the remote
controller to turn off the indication.
When using BRC1E type, refer to the operation
manual attached to the remote controller.
• The indication can be turned off whether in operation
or at stop.
HOW TO CLEAN THE SUCTION GRILLE
1. Open the suction grille.
Simultaneously press the two knobs, slowly down the
suction grille.
2. Remove the straps of the suction grille.
Remove the two straps from the holding parts on the
panel main body to which the straps are attached.
Strap Holding part
Holding
part Strap
3. Remove the suction grille.
Open the suction grille 45 ° and lift it.
Then, unhook it from the place to hook. (3 places)
Place to hook
Hook
4. Take out the air filter.
Refer to clause 2 for “HOW TO CLEAN THE AIR
FILTER”. (Page. 4)