Removal of Air Filters
Si041140
2
Removal Procedure
1. Removal of Air Filters
Procedure
Warning
Be sure to wait for 10 minutes or more after turning off all power
supplies before disassembling work.
Step
Procedure
Points
1. Appearance features
Warning
Dangerous: High voltage
A high voltage is applied to
all the electric circuits of this
product including
thermistors.
When a signal from the
remote controller is
received, the receiving tone
sounds and the operation
lamp flickers immediately to
confirm the signal reception.
When the [ON/OFF] button
is kept pressed for 5
seconds, the forced cooling
operation is performed for
about 15 minutes.
2. Remove the air filters.
1
Open the front panel to
the position where it
stops.
2
Slightly push up the
center of the air filter to
unfasten the 2 hooks.
The air filter is not marked
for difference between the
right and left sides.
The air filter can be set
easily by inserting it along
the guides.
Insert the air filter with the
“FRONT” mark faced up.
Be sure to insert the hooks
(at 2 lower positions) when
mounting the air filter.
Room temperature thermistor
(R16654)
Signal receiver
(R16655)
Operation
lamp
TIMER
lamp
INTELLIGENT
EYE lamp
[ON/OFF] button
(Forced cooling operation [ON/OFF] button)
(R16656)
Front panel
Hook
(R16657)
Air filter