32
1.
Take off the titanium
apatite photocatalytic air-
purifying filter.
• Open the front panel and pull out the air filters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
2.
Clean or replace the titanium
apatite photocatalytic air-
purifying filter.
[Maintenance]
2-1
Vacuum dusts, and soak in cold or
lukewarm water (avoid using warm
or hot water) for about 10 to
15 minutes if dirt is heavy.
• Do not remove the filter from frame when
washing with water.
2-2
After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of polyester, do
not wring out the filter when removing water from
it.
[Replacement]
Remove the filter from the
filter frame and attach a new
one.
• Do not throw away the filter frame. Reuse the
filter frame when replacing the titanium apatite
photocatalytic air-purifying filter.
• Dispose of the old filter as non-flammable waste.
3.
Set the filters as they were
and close the front panel.
• Press the front panel at both sides and the
center.
NOTE
• Operation with dirty filters:
– cannot deodorize the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odour.
• Dispose of old filters as non-flammable waste.
• To order titanium apatite photocatalytic air-purifying
filter contact to the service shop there you bought the
air conditioner.
Item
Titanium apatite photocatalytic
air-purifying filter (without frame) 1 set
Part No.
KAF970A46
■
Titanium apatite photocatalytic air-purifying filter