![background image](http://html1.mh-extra.com/html/daikin/ftx09wmvju9/ftx09wmvju9_operation-manual_4703691011.webp)
Read Before Operation
10
English
To insert the batteries
1.
Remove the back cover by sliding and then
slightly lifting it.
2.
Insert 2 dry batteries AAA.LR03 (alkaline).
3.
Replace the back cover.
To attach the remote controller holder to a wall
1.
Choose a place where the signals reach the unit.
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder.
3.
Hang the remote controller on the remote controller holder.
Fahrenheit/Celsius display switch
Press
and
(TIMER button)
simultaneously for about 5 seconds.
•
The temperature will be displayed in Celsius when it is presently displayed in Fahrenheit, and vice versa.
•
The switch operation is only possible when the temperature is being displayed.
•
A reception sound will go off for the transmission of set temperature to the indoor unit at
the time of setting the Fahrenheit/Celsius display change function.
Turn on the circuit breaker
•
After the power is turned on, the flap of the indoor unit opens and closes once to set the reference position.
Position and
correctly!
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
•
To avoid possible injury or damage from battery leakage or rupturing, remove the batteries when not using the product for long periods of time.
•
The standard replacement time is about 1 year. Both batteries should be replaced at the same time. Be sure to replace them with new dry
batteries AAA.LR03 (alkaline).
•
If the remote controller display begins to fade and signal reception begins to decline, replace the batteries with new batteries. Owing to usage conditions, battery consumption may be accelerated.
•
The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Notes on remote controller
•
Do not drop the remote controller. Do not get it wet.
•
If dirt becomes an issue, wipe with a soft dry cloth.
Fahrenheit/Celsius display change function of remote controller
•
The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
•
Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C.
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the original
set temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
CAUTION
Incorrect handling of batteries can result in injury from battery leakage, rupturing or heating, or lead to equipment failure.
Please observe the following precautions and use safely.
•
If the alkaline solution from the batteries should get in the eyes, do not rub the eyes. Instead, immediately flush the eyes with tap water and
seek the attention of a medical professional.
•
Keep batteries out of reach of children. In the event that batteries are swallowed, seek the immediate attention of a medical professional.
•
Do not expose batteries to heat or fire. Do not disassemble or modify batteries. The insulation or gas release vent inside the battery may be
damaged, resulting in battery leakage, rupturing, or heating.
•
Do not damage or peel off labels on the batteries.
Preparation Before Operation
01_EN_3P686870-1.indd 10
2022/06/03 15:50:52