Daikin FT18JV1B, Operation Manual

Page: 11 / 20

10
POWERFUL
Operation
POWERFUL operation quickly maximizes the
cooling (heating) effect in any operation mode.
You can get the maximum capacity with a touch
of a button.
●
Pressing the (POWERFUL) button during
operation starts POWERFUL operation.
●
POWERFUL operation ends in 20 minutes.
Then the system automatically operates
again with the settings which were used
before POWERFUL operation.
●
During you use “POWERFUL operation”, the
other functions will not go on.
Press .
■ ■
■ ■
■
To cancel POWERFUL operation:
1
Notes on POWERFUL operation
●
In COOL and HEAT mode
To maximize the cooling and heating effect,
the capacity of outdoor unit must be
increased and the air flow rate be fixed to the
maximum setting.
The temperature and air flow settings are not
variable.
●
In DRY mode
The temperature setting is lowered by 3°C
and the air flow rate is slightly increased.
●
In FAN mode
The air flow rate is fixed to the maximum
setting.
Display
Press .
ON
No display
Adjusting the Air
Flow Direction
You can adjust the air flow direction to increase
your comfort.
Adjusting the horizontal
blade (flap)
....... To stop the flap at an
angle you like, press
SWING
.
●
When
SWING
is selected, the flap swinging range
depends on the operation mode. (See the figure.)
●
The real flap angles are differ from the display of
remote controller.
Press
SWING
.
●
Every time the button is pressed, “ ”
appears or disappears.
.......
The flap automatically
swings up and down.
ATTENTION
●
Always use a remote controller to adjust
the flap angle. If you attempt to move it
forcibly with hand when it is swinging,
the mechanism may be broken.
ATTENTION
Hold the knob and
move the louvre.
(You will find a
knob on the left-
side and the right-
side blades.)
Notes on flap angles
●
Be careful when adjusting the louvre. Inside
the air outlet, a fan is rotating at a high speed.
Adjusting the vertical blade
(louvre)
In FAN mode or COOL mode
In HEAT or FAN mode
When stop operation
Upper limit in cooling
Lower limit in cooling
0˚
25˚
20˚
45˚
When stop operation
Upper limit in heating
Lower limit in heating