![background image](http://html1.mh-extra.com/html/daikin/fhycp100dve/fhycp100dve_operation-manual_2459281009.webp)
English
6
•
The movable limit of the flap is changeable.
Contact your Daikin dealer for details.
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as shown
below.
The AIR FLOW FLAP display
swings as shown below and the
air flow direction continuously
varies. (Automatic swing set-
ting)
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air flow
direction is fixed (Fixed air flow
direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer controls
the air flow direction so it may be different from the dis-
play.
Operation mode includes automatic operation.
Operation
mode
Cooling
Heating
Operation
condition
•
When operating
continuously at
horizontal air
flow direction
•
When room
temperature is
higher than the set
temperature
•
At defrost opera-
tion
(Air is blown
horizontally to pre-
vent the cool air
from being blown
directly onto any-
one in the room.)
Up and down adjustment
swing
Operate in the following order.
•
The timer is operated in the following two ways.
•
Programming the stop time (
) .... The sys-
tem stops operating after the set time has elapsed.
•
Programming the start time (
) .... The sys-
tem starts operating after the set time has elapsed.
•
The timer can be programmed a maximum of
72 hours.
•
The start and the stop time can be simultaneously
programmed.
TIMER MODE START/STOP
Press the TIMER MODE START/STOP button
several times and select the mode on the dis-
play.
The display flashes.
For setting the timer stop .... “
”
For setting the timer start .... “
”
PROGRAMMING TIME
Press the PROGRAMMING TIME button and set
the time for stopping or starting the system.
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “
or
” changes from flash-
ing light to a constant light.
Refer to figure 4 on page [1]
NOTE
•
When setting the timer Off and On at the same time,
repeat the above procedure from to once again.
When the timer is programmed to stop the system
after 3 hours and start the system after 4 hours, the
system will stop after 3 hours and then 1 hour later
the system will start.
•
After the timer is programmed, the display shows
the remaining time.
•
Press the TIMER ON/OFF button once again to
cancel programming. The display vanishes.
PROGRAM TIMER OPERATION
1
2
3
1
3
01_EN_3P083810-1W.fm Page 6 Friday, October 14, 2005 1:56 PM