background image

5

English

 Refer to figure 1 on page [1] 

Operating procedure varies with heat pump type 
and cooling only type. Contact your Daikin dealer 
to confirm your system type. 

To protect the unit, turn on the main power switch 
6 hours before operation.

If the main power supply is turned off during oper-
ation, operation will restart automatically after the 
power turns back on again.

Operate in the following order.

13

NON-FUNCTIONING DISPLAY

If that particular function is not available, 

pressing the button may display the words 

“NOT AVAILABLE” for a few seconds.

When running multiple units simultaneously

The “NOT AVAILABLE” message will only be 

appear if none of the indoor units is equipped 

with the function. If even one unit is equipped 

with the function, the display will not appear.

14

TIMER MODE START/STOP BUTTON

Refer to “PROGRAM TIMER OPERATION”.

15

TIMER ON/OFF BUTTON

Refer to “PROGRAM TIMER OPERATION”.

16

INSPECTION/TEST OPERATION BUTTON

This button is used only by qualified service 
persons for maintenance purposes.

17

PROGRAMMING TIME BUTTON

Use this button for programming “START and/
or STOP” time.

18

TEMPERATURE SETTING BUTTON

Use this button for SETTING TEMPERATURE.

19

FILTER SIGN RESET BUTTON

Refer to “HOW TO CLEAN THE AIR FILTER”.

20

FAN SPEED CONTROL BUTTON

Press this button to select the fan speed, 

HIGH or LOW, of your choice.

21

OPERATION MODE SELECTOR BUTTON

Press this button to select OPERATION MODE.

22

AIR FLOW DIRECTION ADJUST BUTTON

Refer to “ADJUSTING THE AIR FLOW 

DIRECTION”.

NOTE

For the sake of explanation, all indications are 

shown on the display in figure 1 contrary to 

actual running situations.

6. OPERATION PROCEDURE

COOLING, HEATING, AUTOMATIC, FAN, 
AND PROGRAM DRY OPERATION

OPERATION MODE SELEC-

TOR

Press OPERATION MODE SELECTOR but-

ton several times and select the OPERA-

TION MODE of your choice as follows.

 

COOLING OPERATION ......................... “

 

HEATING OPERATION.......................... “

 

AUTOMATIC OPERATION..................... “

In this operation mode, COOL/HEAT 
changeover is automatically conducted.

 

FAN OPERATION................................... “

 

DRY OPERATION .................................. “

The function of this program is to decrease the 
humidity in your room with the minimum tem-
perature decrease.

Micro computer automatically determines 
TEMPERATURE and FAN SPEED.

This system does not go into operation if the 
room temperature is below 16°C.

 Refer to figure 3 on page [1] 

For cooling only type, “COOLING”, “FAN” and 
“DRY” operation are able to select.

 ON/OFF

Press ON/OFF button

OPERATION lamp lights up or goes off and the sys-

tem starts or stops OPERATION.

[ EXPLANATION OF HEATING OPERATION ]

DEFROST OPERATION

As the frost on the coil of an outdoor unit increase, 
heating effect decreases and the system goes 
into DEFROST OPERATION.

The indoor unit fan stops and the remote control-
ler display shows “

”.

After 6 to 8 minutes (maximum 10 minutes) of 
DEFROST OPERATION, the system returns to 
HEATING OPERATION.

Regarding outside air temperature and heat-

ing capacity

The heating capacity of the air conditioner 
declines as the outside air temperature falls. In 
such a case, use the air conditioner in combina-
tion with other heating systems.

A warm air circulating system is employed, and 
therefore it takes some time until the entire room 
is warmed up after the start of operation.

1

2

01_EN_3P170549-3.fm  Page 5  Friday, December 9, 2005  11:45 AM

Summary of Contents for FAY71FVE
















Reviews: