10
English
1. Open the front panel.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
2. Remove the front panel.
Push the axis on either side of the front panel
towards the center of the main unit and remove
it.
(You can also remove it by sliding the front panel
either to the left or right and pulling it forward.)
3. Clean the front panel.
•
Wipe gently with a soft wet cloth.
•
Only use neutral cleaning agents.
•
After washing, wipe off the remaining water
completely and dry in the shade.
4. Attach the front panel.
Set the keys of the front panel into the slots and
push them in all the way.
Close the front panel slowly in this state.
5. Close the front panel.
[CLEANING BEFORE AND AFTER SEA-
SONAL USE]
START UP AFTER A LONG STOP
Confirm the following
•
Check that the air inlet and outlet are not blocked.
Remove any obstacle.
Obstacles may decrease the airflow rate, leading to
performance decline and breakage of the devices.
Clean the air filter
•
After cleaning the air filter, make sure to attach it.
(Refer to “MAINTENANCE” on page 8.)
•
After cleaning, press AIR FILTER CLEANING
TIME ICON RESET BUTTON.
Turn on the power circuit breaker at least
6 hours before operation.
•
To protect the unit, this is required in order to acti-
vate the unit smoothly.
•
The display on the remote controller will be shown
when the power circuit breaker is turned on.
HEATING OPERATION within 6 hours after the
power is supplied to the power circuit breaker.
•
Some models perform the following operation to
protect the devices.
If the HEATING OPERATION is performed within
6 hours after the power is supplied to the power
circuit breaker, the indoor fan stops for about 10
minutes during the outdoor unit operation to pro-
tect the devices.
The above operation is performed not only at the
time of installation, but every time the power cir-
cuit breaker is turned on/off.
For comfort heating, it is recommended not to
turn off the power circuit breaker during HEATING
OPERATION.
WHAT TO DO TO STOP THE SYSTEM FOR A
LONG PERIOD
•
This will prevent generation of mould.
Turn off the power circuit breaker.
•
When the power circuit breaker is turned on, low
wattage is consumed even if the system is not
operating.
Turn off the power circuit breaker for saving
energy.
•
The display on the remote controller will vanish
when the power circuit breaker is turned off.
Clean the air filter.
•
Be sure to replace the air filter to its original place
after cleaning.
(Refer to “MAINTENANCE” on page 8.)
3P184442-10J_FM6.book Page 10 Wednesday, December 14, 2011 3:38 PM
