NOTE
•
Do not wash the air filter with water of 50°C or
higher. It may cause decolorization and
deformation.
•
When drying the filter, do not heat it with fire.
It may cause burning.
•
Do not use such as gasoline, benzine, thinner,
polishing powder and liquid insecticide sold
in the market.
4. Attach the air filter.
5. Close the front panel.
1. Open the front panel.
Once cleaning is done be sure to replace the air
filter as it was.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
HOW TO CLEAN THE FRONT PANEL
You can remove the front panel to clean it.
6. Turn off the indication “
” or “Time to clean
filter” displayed on the remote controller after
turning on the power.
•
For details, refer to the operation manual
attached to the remote controller. The
indication can be turned off whether in
operation or at stop.
11
CAUTION
• Hold the front panel firmly so that it does not fall
.
• Do not use water which is 50°C or more, benzene
,
gasoline, thinner, or other volatile substances,
polishing powder, or hard scrub brushes to clean
the panel.
• Do not expose it to fine, as doing so may result i
n
burning.
• Make sure the front panel is solidly in place
.
2. Remove the front panel.
Push the axis on either side of the front panel
towards the center of the main unit and remove
it.
(You can also remove it by sliding the front panel
either to the left or right and pulling it forward.)
3. Clean the front panel.
• Wipe gently with a soft wet cloth.
• Only use neutral cleaning agents.
• After washing, wipe off the remaining water
completely and dry in the shade.
4. Attach the front panel.
5. Close the front panel.
Set the keys of the front panel into the slots and
push them in all the way.
Close the front panel slowly in this state.
