IM 871-3
Page 3 of 12
Relocating the Control Pad
Before reinstalling the chassis into the cabinet/wall sleeve, do
the following:
1. Locate the retaining clips (see
)
holding the control pad to the chassis. Release the clips on
the Control Pad and set pad on chassis.
2. Slide the chassis into the cabinet/wall sleeve.
3. Lift the primary discharge section control door and angle
the control pad up and through the primary discharge
section control door opening. Check the communication
cable for proper connection to the Touchpad and the control
board.
Figure 5: Position and tighten screws on mounting brackets to secure primary discharge section to cabinet/wall sleeve.
Locate Right and Left Mounting Bracket
Primary Discharge Section
Mounting Bracket Assembly
Mounting Bracket Detail
4. Snap control pad into the primary discharge section control
pad opening.
To continue the ExtendAire installation refer to
Installation Procedure Common to Models PDAE/PDHE and
PDAF/PDHF" on page 6
