3 About the box
Installation manual
7
EWAA011~016DA + EWYA009~016DA
Packaged air-cooled water chillers
and packaged air to water heat pumps
4P620240-1 – 2020.06
WARNING
Rotating fan.
Before powering ON the outdoor unit, make
sure that the discharge grille covers the fan as protection
against a rotating fan. See
"4.2.4 To install the discharge
9].
WARNING
ALWAYS use multicore cable for power supply cables.
CAUTION
Do NOT push or place redundant cable length in the unit.
WARNING
The backup heater MUST have a dedicated power supply
and MUST be protected by the safety devices required by
the applicable legislation.
CAUTION
To guarantee the unit is completely earthed, always
connect the backup heater power supply and the earth
cable.
WARNING
Stripped wire.
Make sure that stripped wire cannot make
contact with possible water on the bottom plate.
33])
WARNING
Commissioning method MUST be in accordance with the
instructions
from
this
manual.
See
3
About the box
3.1
Outdoor unit
3.1.1
To remove the accessories from the
outdoor unit
NOTICE
Unpacking – Top packaging.
When you remove the top
packaging, hold the box containing the discharge grille to
prevent it from falling.
1
Remove the accessories on top and in front of the unit.
a
g
d
b
c
e
f
ENERG
IJA
Y
IA
IE
ENERG
IJA
Y
IA
IE
h
i
a
Slings to carry the unit
b
General safety precautions
c
Operation manual
d
Installation manual
e
Addendum book for optional equipment
f
Energy label
g
User interface (front plate, rear plate, screws, and wall
plugs)
h
Discharge grille
i
Screws for discharge grille
2
After opening the unit (see
9]), remove the accessory inside the unit.
j
j
Shut-off valve (with integrated filter)
4
Unit installation
4.1
Preparing the installation site
4.1.1
Installation site requirements of the
outdoor unit
Mind the spacing guidelines. See figure 1 on the inside of the front
cover.
Translation of text on figure 1:
English
Translation
Discharge-side obstacle
Discharge-side obstacle