English
22
ON TIMER Operation
■
To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
Page 10
1.
Press
.
• “
” is displayed on the LCD.
• “ ” blinks.
•
“
” and day of the week disappear from the LCD.
2.
Press
until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press
again.
•
“
” and setting time are displayed on the LCD.
• The TIMER lamp lights yellow.
Page 5
Display
■
To cancel ON TIMER operation
Press
.
•
“
” and setting time disappear from the LCD.
•
“
” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
■
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
■
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
01_EN_3P297033-1.indd 22
10/12/2011 2:15:18 PM
