Preparation Before Operation
CAUTION
Incorrect handling of batteries can result in injury from battery leakage, rupturing or heating, or lead to equipment failure.
Please observe the following precautions and use safely.
• If the alkaline solution from the batteries should get in the eyes, do not rub the eyes. Instead, immediately flush the eyes with tap
water and seek the attention of a medical professional.
•
Keep batteries out of reach of children. In the event that batteries are swallowed, seek the immediate attention of a medical professional.
• Do not expose batteries to heat or fire. Do not disassemble or modify batteries. The insulation or gas release vent inside the battery
may be damaged, resulting in battery leakage, rupturing, or heating.
•
Do not damage or peel off labels on the batteries.
To insert the batteries
1.
Slide the front cover to take it off.
2.
Insert 2 dry batteries AAA.LR03 (alkaline).
3.
Replace the front cover.
To attach the remote controller holder to a wall
1.
Choose a place from where the signals reach
the unit.
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the
holder.
3.
Place the remote controller in the remote
controller holder.
Position and
correctly!
+
–
2
3
1
Grip both
sides of the
front cover.
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
•
To avoid possible injury or damage from battery leakage or rupturing, remove the batteries when not using the product for long periods
of time.
•
The standard replacement time is about 1 year. Both batteries should be replaced at the same time. Be sure to replace them with new
size AAA.LR03 (alkaline) batteries.
•
When battery power has run out, “
” will begin blinking on the LCD as an alert that the batteries need replacing. In some cases,
when battery consumption is accelerated owing usage conditions, signal reception may decline before the LCD begins blinking.
•
The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Note on remote controller
•
Do not drop the remote controller. Do not get it wet.
5
Read before Operation
01_EN_3P477582-2.indd 5
6/14/2017 14:12:43
Summary of Contents for CDXP25RVMA
