Daikin BS1Q10A7V1B, Installation Manual

Page: 5 / 24

English 2
•
Install the air conditioner on a foundation strong enough to withstand the weight of the unit.
A foundation of insufficient strength may result in the equipment falling and causing injury.
•
Carry out the specified installation work after taking into account strong winds, typhoons or
earthquakes.
Failure to do so during installation work may result in the unit falling and causing accidents.
•
Make sure that a separate power supply circuit is provided for this unit and that all electrical work
is carried out by qualified personnel according to local laws and regulations and this installation
manual.
An insufficient power supply capacity or improper electrical construction may lead to electric
shocks or fire.
•
Be sure to earth the air conditioner.
Do not earth the unit to a utility pipe, lightning conductor or telephone earth lead. Imperfect
earthing may result in electric shocks or fire.
A high surge current from lightning or other sources may cause damage to the air conditioner.
•
Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in electric shocks or fire.
•
Be sure to switch off the unit before touching any electrical parts.
•
Make sure that all wiring is secured, the specified wires are used, and that there is no strain on the
terminal connections or wires.
Improper connections or securing of wires may result in abnormal heat build-up or fire.
•
When wiring the power supply and connecting the wiring between the indoor and outdoor units,
position the wires so that the EL. COMPO. BOX lid can be securely fastened.
Improper positioning of the EL. COMPO. BOX lid may result in electric shocks, fire or the terminals
overheating.
•
If refrigerant gas leaks during installation, ventilate the area immediately.
Toxic gas may be produced if the refrigerant gas comes into contact with fire.
•
After completing installation, check for refrigerant gas leakage.
Toxic gas may be produced if the refrigerant gas leaks into the room and comes into contact with
a source of fire, such as a fan heater, stove or cooker.
•
Do not directly touch refrigerant that has leaked from refrigerant pipes or other areas, as there
is a danger of frostbite.
CAUTION
•
Install the BS units, power cord and connecting wires at least 1 meter away from televisions or
radios to prevent picture interference and noise.
(Depending on the incoming signal strength, a distance of 1 meter may not be sufficient to
eliminate noise.)
•
Remote controller (wireless kit) transmitting distance can be shorter than expected in rooms with
electronic fluorescent lamps (inverter or rapid start types).
Install the BS unit as far away from fluorescent lamps as possible.
•
Make sure to provide for adequate measures in order to prevent that the outdoor unit be used as
a shelter by small animals.
Small animals making contact with electrical parts can cause malfunctions, smoke or fire. Please
instruct the customer to keep the area around the unit clean.
•
Do not install the air conditioner in the following locations:
1. Where there is a high concentration of mineral oil spray or vapour (e.g. a kitchen).
Plastic parts will deteriorate, parts may fall off and water leakage could result.
2. Where corrosive gas, such as sulphurous acid gas, is produced.
Corroding of copper pipes or soldered parts may result in refrigerant leakage.
3. Near machinery emitting electromagnetic radiation.
Electromagnetic radiation may disturb the operation of the control system and result in a
malfunction of the unit.