Daikin BRC7E61W, Opration Manual, Page: 6 / 17

2 English
Do not place any burning appliance in the
air current from the air conditioner, since
such appliance may suffer incomplete
combustion.
Never place nor use any inflammable
sprays near the air conditioner, since
such sprays could cause a fire.
2. NAMES AND FUNCTIONS
OF THE OPERATING SEC-
TION (Fig. 1, 2)
1
DISPLAY “ ” (SIGNAL TRANSMIS-
SION)
This lights up when a signal is being
transmitted.
2
DISPLAY “ ” “ ” “ ” “ ”
“ ” (OPERATION MODE)
This display shows the current OPER-
ATION MODE. For cooling only type,
“
” (Auto) and “ ” (Heating) are
not installed.
3
DISPLAY “ ” (SET TEMPERATURE)
This display shows the set temperature.
4
DISPLAY “ ”
(PROGRAMMED TIME)
This display shows PROGRAMMED
TIME of the system start or stop.
5
DISPLAY “ ” (AIR FLOW FLAP)
Refer to page 7.
6
DISPLAY “ ” “ ” (FAN SPEED)
The display shows the set fan speed.
7
DISPLAY “ ”
(INSPECTION/ TEST OPERATION)
When the INSPECTION/TEST OPER-
ATION BUTTON is pressed, the display
shows the system mode is in.
M H L
C
hr. hr.
TEST
8
ON/OFF BUTTON
Press the button and the system will
start. Press the button again and the
system will stop.
9
FAN SPEED CONTROL BUTTON
Press this button to select the fan
speed, HIGH or LOW, of your choice.
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPER-
ATURE (Operates with the front cover
of the remote controller closed.)
11
PROGRAMMING TIMER BUTTON
Use this button for programming
“START and/or STOP” time. (Operates
with the front cover of the remote con-
troller opened.)
12
TIMER MODE START/STOP BUTTON
Refer to page 7.
13
TIMER RESERVE/CANCEL BUTTON
Refer to page 8.
14
AIR FLOW DIRECTION ADJUST BUTTON
Refer to page 7.
15
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION
MODE.
16
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE
in the operation manual attached to the
indoor unit.
17
INSPECTION/TEST OPERATION
BUTTON
This button is used only by qualified
service persons for maintenance
purposes.
18
EMERGENCY OPERATION SWITCH
This switch is readily used if the remote
controller does not work.
19
RECEIVER
This receives the signals from the
remote controller.