English
9
When attempting settings than that
consented above, a “peep” is emitted as a
warning.
Only with Heat recovery system, you can set
the indoor unit to AUTOMATIC. Attempting
to do so, a “peep” will be emitted as a warn-
ing.
How to designate the master remote
controller
Operate in the following order.
Continuously press the OPERATION
MODE SELECTOR button for 4 seconds.
The displays showing “
” of all slave
indoor unit connected to the same outdoor
unit or BS unit flash.
Press the OPERATION MODE SELEC-
TOR button to the indoor unit that you
wish to designate as the master remote
controller. Then designation is com-
pleted. This indoor unit is designated
as the master remote controller and
the display showing “
” vanishes.
•
To change settings, repeat steps
and
.
When the remote controller does not work
due to battery failure or the absence thereof,
use this switch which is located beside the
discharge grille on the main unit. When the
remote controller does not work, but the
battery low indicator on it is not lit, contact
your dealer.
[START]
To press the emergency opera-
tion switch.
The machine runs in the previous mode.
The system operates with the previously set
air flow direction.
1
MODE
2
MODE
EMERGENCY OPERATION
1
2
1
[STOP]
Press the EMERGENCY OPERA-
TION switch again.
This system provides two other control
systems beside individual control (one
remote controller controls one indoor unit)
system. Confirm the following if your unit is of
the following control system type.
Group control system
One remote controller controls up to 16
indoor units.
All indoor units are equally set.
Two remote controller control system
Two remote controllers control one indoor
unit. (In case of group control system, one
group of indoor units)
The unit follows individual operation.
NOTES
•
Cannot have two remote controller control
system with only wireless remote control-
lers. (It will be a two remote controller con-
trol system having one wired and one
wireless remote controllers.)
•
Under two remote controller control sys-
tem, wireless remote controller cannot
control timer operation.
•
Only the operating indicator lamp out of 3 other
lamps on the indoor unit display functions.
NOTE
•
Contact your Daikin dealer in case of
changing the combination or setting of
group control and two remote controller
control systems.
PRECAUTIONS FOR GROUP
CONTROL SYSTEM OR TWO
REMOTE CONTROLLER
CONTROL SYSTEM
1 2
2
01_EN_3P107422-10F.fm Page 9 Wednesday, August 31, 2005 1:44 PM
