![background image](http://html1.mh-extra.com/html/daikin/bae20a82/bae20a82_installation-and-operation-manual_4699114013.webp)
11
D
UST
COLLECTION
WITH
VACUUM
CLEANER
1
Vacuum the dust in the dust box on completion of confirming the
dust collection sign.
2
Connect the provided connection pipe and attachment to match
the vacuum cleaner pipe.
Insert the connection pipe and attachment into the vacuum
cleaner pipe.
When storing the connection pipe, use the provided hook-and-loop
fastener strip and take the following procedure.
Example 1
1
Peel the release paper off the double-stick tape on the back of
the fastener strip, and paste the fastener strip onto a flat surface
in the place of storage.
2
Press the fastener strip of the connection pipe onto the fastener
strip pasted in step 1.
Example 2
Wind the hook-and-loop fasteners on the connection pipe around a
vacuum cleaner hose or pipe to store the connection pipe.
3
Insert the leading end of the connection pipe into the dust
collection inlet of the suction grille from right under. Then press
fit the leading end onto internal air inlet until the leading end
snaps.
4
While the leading end of the connection pipe closely come in
contact, turn on the vacuum cleaner with the suction power set
to maximum and vacuum the dust for at least 10 seconds.
While vacuuming the dust take away the hose and put it back
several times.
NOTE
Dust collection with a vacuum cleaner is not
possible during filter auto cleaning. Make sure
that "
" is not displayed on the remote
controller screen before dust collection.
NOTE
The connection pipe can be purchased separately as
option BAEVACEP. It is not delivered together with the
Auto-Cleaning option kit.
1
Vacuum cleaner pipe with an inner diameter of 32 to 38 mm in
diameter
2
Vacuum cleaner pipe with an inner diameter of 38 to 42 mm in
diameter
3
Vacuum cleaner pipe
4
Connection pipe
5
Attachment
1
Example 1
2
Example 2
3
Connection pipe
4
Vacuum cleaner hose or pipe
5
Flat surface in the place of storage
6
Hook-and-loop fastener strips
1
3
4
2
3
5
4
3
4
6
6
5
1
2
NOTE
The attachment cannot be connected to a vacuum
cleaner pipe without a round-shaped leading end
(e.g., a stand-type or handheld-type vacuum
cleaner) or a pipe that has a hole midway to
cause air leakage. Consult your Daikin dealer if
the attachment cannot be connected to your
vacuum cleaner.
Use a vacuum cleaner with a minimum sucking
work rate of 300 W.
Do not use a vacuum cleaner full of dust and low
in suction power.
* The use of the above vacuum cleaner may result in a
dust collection failure.
1
Dust collection inlet
2
Air inlet
3
Connection pipe
4
Rises approximately 10mm
1
3
2
4
4PEN470901-1B.book Page 11 Thursday, September 7, 2017 3:17 PM