Daihen WB-M500, Owner'S Manual

Page: 18 / 145

S
PECIFICATION
P
RODUCT
S
PECIFICATION AND
C
ONFIGURATION
C
HAPTER
2
2-2
2.1.2 Applicable welding method
This section explains the applicable welding method (shield gas/wire type/welding type) and wire
diameter.
Standard specification
GAS (*1) WIRE MATERIALS WIRE DIA. (mm) TRAVEL SPEED
Penetration
adjustment
CO
2
MILD STEEL 1.0/1.2/1.6 (*2) (*3) Enable
MILD STEEL CORED 1.2/1.6 STANDARD (*3) Enable
STAINLESS CORED 1.2/1.6 STANDARD (*3) Enable
MAG (20 % CO
2
)
(*1-1)
MILD STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
MILD STEEL CORED 1.2/1.6 STANDARD (*3) Enable
STAINLESS CORED 1.2/1.6 STANDARD (*3) Enable
MAG (10 % CO
2
)
(*1-2)
MILD STEEL 0.8/1.0/ 1.2 (*2) (*3) Enable
MIG (2 % O
2
)
(*1-3)
STAINLESS STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
STAINLESS FERRITE 1.2 (*2) (*3) Enable
MIG (2.5 % CO
2
)
(*1-4)
STAINLESS STEEL 0.8/1.0/1.2/1.6 (*2) (*3) Enable
MIG (100 % Ar)
(*1-5)
Al/PURE 1.2/1.6 (*2) (*3) -
Al/Mg 1.0/1.2/1.6 (*2) (*3) -
Brazing CuSi 0.8/1.0/1.2 (*2) (*3) -
Brazing CuAl 0.8/1.0/1.2 (*2) (*3) -
*1: Note that the "collective" voltage adjustment may not meet the appropriate condition if a mixing gas other than those
with the following mixing ratios is used.
*1-1: MAG gas: Argon (Ar) 80 % + Carbon dioxide (CO
2
)20 %
*1-2: MAG gas: Argon (Ar) 90 % + Carbon dioxide (CO
2
)10 %
*1-3: MIG gas (stainless steel): Argon(Ar) 98 % + Oxygen (O
2
)2 %
*1-4: MIG gas: Argon(Ar)97.5 % + Carbon oxygen (CO
2
)2.5 %
*1-5: MIG gas (Aluminum/Aluminum bronze/Silicon bronze): Argon (Ar)100 %
*2: Available for applications either of "STANDARD" or "HIGH".
*3: For "STANDARD" mode, the standard mode or extended cable mode (extended mode of power cable) is available.
( 6.7.2.1
-
F1: Standard/Extended cable mode)