Daihan Scientific WiseSpin CF-10, Operation Manual

Page: 17 / 43

DAIHAN-Sci.com / ALL
for LAB.com
WiseSpin
®
CF-10 Personal Table-top Centrifuge
17/37
of timer SV, the set values is changed. Timer will automatically begin to run, at the moment that
the rpm PV reaches to rpm SV by the Rotation operation.
Saving current SV
: You could save the current timer SV for the re-use in next time by pushing
the jog-shuttle knob for one second. The unit stores the set value in nonvolatile memory, so you
could re-use it afterwards.
If you finish setting timer, push MODE button. you can enter into the Locking mode.
(NOTE)
Timer resolution is 1 second and maximum timer value is 99min 59sec. If you set timer
to “0”, rotation will be continued without stopping.
5. Locking Mode
If you push MODE button in Set Timer mode, the unit enters into Safety Locking mode. In this
mode, the PVs of rpm and timer are shown on LCD. And any action (turn or push) to jog-shuttle
knob is disabled and pushing SPIN button is also disabled. So, the operator can prevent the unit
from change of the operation by mistake and can monitor the operation safely. If you push the
MODE button
○
13
again in this mode, the unit enters into the Set Rotation Speed mode.
6. SPIN mode
This mode is very convenient for repetitive use of a certain combination of rotation speed & time.
If you push SPIN button
○
14
in Set Rotation Speed mode or in Set Timer mode, the unit enters
into the SPIN mode. By simply clicking the jog-shuttle knob at this moment, the unit starts
operation promptly with the rotation speed and timer SVs saved previously.
If you want to change the SVs of rotation speed and timer, push the jog-shuttle knob for one
second. Then the unit enters into the Set SPIN Rotation Speed mode. Like in the Set Rotation
Speed mode, you can change the rpm by turning jog-shuttle knob. After setup the rotation speed,
push the SPIN button again (Save & go to next set up), then the current set rpm is saved and
the unit enters into the Set SPIN Timer mode. Like in the Set Timer mode, you can change the
timer SV by turning jog-shuttle knob. After setup the timer, push the SPIN button once again
(Save & go to next set up), then the current timer SV is saved and the unit enters into the Set
SPIN Rotation Speed mode again.
When you finished setup of the rotation speed and timer for SPIN operation, push the jog-shuttle