Operation Manual
Parameter
Description
Click on
of IP address. Obtain the MAC address of the camera so that
you can change and configure the IP address of the device with
the ARP/ping command.
to enable ARP/Ping and configure the service
This feature is enabled by default. During the reboot, you will
have no more than 2 minutes to set the IP address of the device
using a ping packet with a certain length; The server will
shutdown in 2 minutes or shutdown immediately after the IP
address is set successfully. If it is not enabled, the IP address
cannot be set with the ping packet.
Demonstration of how to configure IP address with
ARP/Ping.
1. Keep the camera to be configured and the PC within the
same local network, and then obtain a usable IP address.
2. Obtain the MAC address of the camera from the device
label.
3. Open the command editor on the PC and enter the
following command.
ARP/Ping
4. Reboot the camera.
5. Check the PC command line; if the informational message
appears
Reply from 192.168.0.125
…(Reply from
192.168.0.125…), the setup will be done successfully, and
you can turn off the camera.
6. Enter http://(IP Address) in the browser's address bar to log in.
Select the Ethernet card to be configured and the default
is
With cable
(Wired).
IAS
14
