13
Step 1
Fix the device on the mounting surface.
1. Select a flat mounting surface (wall or ceiling and so on); stick the installation position map on the proper
position.
2. Dig holes according to the four mounting hole sites marked on the installation position map. The size
and depth of hole diameter need to be matched with expansion bolts, make sure there is no deviation for
the hole sites.
3. Open accessory bag, take out expansion bolts, use the hammer to knock the expansion bolts into the
holes which have been well dug, the external part of expansion bolt has to be parallel and level with the
mounting surface.
4. Open accessory bag, take out mounting screws, align 4 mounting holes on the camera bracket with 4
mounting holes of expansion bolts, push the mounting screws through bracket hole and insert them into
the mounting holes of expansion bolt, lock 4 mounting screws firmly and fix the device on the mounting
surface stably (wall or ceiling).
Step 2
Connect the external cable well according to the requirements.
1. Connect the corresponding power, video output and other ports well according to requirements, and
then use insulated rubber tape to twine the connection joint well to make it waterproof.
Note
The video port is covered with heat-shrinkable tube with high shrinkage ratio, it needs to heat and shrink
the tubes on both sides after the video port is well connected, which is to make sure the video port is
moistureproof and waterproof.
The grounding hole is recommended to be grounded, which is to enhance device reliability.
2. It is to install waterproof cover for network port according to actual implementation by referring to step 3
(optional).
3. Please refer to 4.4 Alarm Setup for alarm input and output cable connection and config.
4. It can properly lengthen device cable according to actual construction requirements.
Step 3
(Optional) Install waterproof connector for network port.
Note
It needs to implement the following operation when the device is equipped with waterproof connector and it
is used outdoors.
Figure 3-3
