5
3.2
Installation Steps
3.2.1 Installation Conditions
The ceiling-mounted speed dome can be installed on the hard ceiling in the indoor environment.
The ceiling needs to satisfy the following installation conditions:
The ceiling shall be thick enough to install the expansion bolt.
The ceiling can sustain at least 8X weight of the speed dome and bracket.
3.2.2 Installation Steps
Note
There are two wiring modes for ceiling-mounted installation.
It supports open wiring from side of the device if it fails to dig holes on the ceiling.
It supports concealed wiring inside the ceiling if it digs holes on the ceiling.
Step 1
Install the default pedestal seal ring of the speed dome on the pedestal according to the method
shown in Figure 3-1
Step 2
Confirm installation position and wiring mode first; mark punching position and dig holes on the
ceiling according to the installation position map, and then insert three plastic expansion bolts
into the holes you just dug.
Step 3
Use inner hex wrench to loosen three locking screws on the enclosure and then remove the
enclosure.
Step 4
Lay the outgoing line well according to wiring mode, use three self-tapping screws to fix the
pedestal on the mounting surface, insert the screws into the expansion bolts which have been
pre-embedded.
Step 5
Adjust the lens direction to proper monitoring position according to the direction which is shown
in Figure 3-2.
Step 6
Use three locking screws to fix the dome enclosure on the pedestal.
So far, the camera installation and cable connection have been completed, and you can adjust
the lens angle, zoom and focus on the WEB interface.