13
Figure 3-3
Figure 3-4
During wiring, it is suggested that wiring harness should divide into signal harness and power
harness, go out of two holes respectively and connect waterproof joints. If all wires goes out of one
hole and connect waterproof joint, it is suggested that the other hole should be covered with
waterproof plug, in order to prevent water leakage.
3.3
Bracket Model
The bracket is not included in basic configuration of the housing. Please buy it if it is needed.
Anti-corrosion protective housing shall be matched with specific anti-corrosion bracket.
Please refer to Table 3-1 for bracket models corresponding to all installation and hanging modes.
Summary of Contents for PFH610V-IR
Page 1: ...Light duty Protective Housing User s Manual V1 0 2 ZHEJIANG DAHUA VISION TECHNOLOGY CO LTD...
Page 11: ...6 Figure 2 4 Wiring Diagram of IPC Interface Remote Mode 2...
Page 12: ...7 Figure 2 5 Wiring Diagram of IPC Interface Routine Mode...
Page 13: ...8 Figure 2 6 Wiring Diagram of CVI Interface Remote Mode 1...