Dahua NVR4204-P-4KS2, User Manual

Page: 122 / 411

107
Port Name Function
1
～
16
Alarm input port
1
～
16

There are four groups. The first group is from
port 1 to port 4, the second group is from port 5
to port 8, the third group is from 9 to 12, and
the fourth group is from 13 to 16. They are to
receive the signal from the external alarm
source. There are two types; NO (normal
open)/NC (normal close).

When your alarm input device is using external
power, please make sure the device and the
NVR have the same ground.
GND Alarm input ground port.
NO1
～
NO5 Alarm output port
1
～
5

5 groups of alarm output ports. (Group 1
：
port
NO1
～
C1,Group 2:port NO2
～
C2,Group 3:port
NO3
～
C3, Group 4
：
port NO4
～
C4, Group 5:
port NO5, C5, NC5).Output alarm signal to the
alarm device. Please make sure there is power
to the external alarm device.

NO: Normal open alarm output port.

C: Alarm output public end.

NC: Normal close alarm output port.
C1
～
C5
NC5
A
RS-485
communication
port
RS485_A port. It is the cable A. You can connect to
the control devices such as speed dome PTZ.
B RS485_B.It is the cable B. You can connect to the
control devices such as speed dome PTZ.
CTRL 12V /
Controller 12V power output. It is to control the
on-off alarm relay output. It can be used to control
the device alarm output. At the same time, it can
also be used as the power input source of some
devices such as the alarm detector.
+12V /
+12V power output port. It can provide the power to
some peripheral devices such as the camera or the
alarm device. Please note the supplying power
shall be below 1A.
Network port
10M/100M/1000Mbps self-adaptive Ethernet port.
Connect to the network cable.
eSATA eSATA port External SATA port. It can connect to the device of
the SATA port. Please jump the HDD when there is
peripheral connected HDD.
USB2.0 port USB2.0 port. Connect to mouse, USB storage
device, USB burner and etc.
RS-232 RS-232 debug
COM.
It is for general COM debug to configure IP address
or transfer transparent COM data.