19
Step 5. After you completed the focus setup, use the slotted screwdriver to fix the screw firmly.
Fasten the focusing ring. Now the installation completed.
Install CS type lens
Step 1. Remove the CCD protection cap from the device.
Step 2. Line up the CS lens to the lens installation position of camera focusing ring. Turn
clockwise to fix the lens.
Step 3. Use slotted screwdriver to fasten the screw near the focusing ring and then turn counter
clockwise to move the focusing ring out for several millimeters. Now you can focus manually
and check the video is clear or not. If you cannot see the clear video, you can adjust via the
flange-back.
Step 4. After you completed the focus setup, use the slotted screwdriver to fix the screw firmly.
Fasten the focusing ring. Now the installation completed.
3.1.2 Remove Lens
Please follow the steps listed below to remove lens. The interface is shown as in Figure 3- 3
Remove lens.
Requirements for recording audio:
1. A single file size cannot exceed 800K or free space.
2. User customized audio file cannot exceed 8.
3. During recording, you must enable main stream audio since without stream, recording will
fail.
4. Record max length is 30s. Overtime and insufficient capacity will cause recording to end
automatically.
Step 1. Turn the lens counter clockwise and then remove it from the camera.
Step 2. Unplug the auto lens cable socket from the auto lens connector. If you are using the
manual aperture lens, please skip to the following step.
Step 3. If there is no lens, please put the CCD protection cap back to protect the CCD.
Figure 3- 3 Remove lens
3.2 SD Card
3.2.1 Installation
