17
Figure 2-12
Step 1
Take the installation position map from the accessories bag and then paste it on the installation ceiling
or the wall according to the monitor area. Please dig three bottom holes of the plastic expansion bolts
according to the map. Take three expansion bolts from the accessories bag and then insert them to
the holes you just dug and then fix firmly. If you want to dig a hole on the installation surface and pull
through the cable, you need to dig a cable exit hole (position and size are determined by the
installation position map) on the installation surface according to the installation positioning map.
Step 2
Use the inner hex wrench from the accessories bag to unfasten the 3 hex screws on the dome camera
enclosure to open it. Remove the dome enclosure.
Step 3
Adjust the chassis of the device to the proper position and pull the cable through the cable exit of the
installation surface. Line up the holes of the chassis to the three expansion bolt holes you dug in Step
1. Take three self-tapping screws and secure them in the three plastic expansion bolts. Now the
chassis is secure on the installation surface.
Important
Please earth the device GND hole
(GND) to enhance the reliability of the device. You must
earth the device GND hole when you install the device outdoors. The GND port is near the
cable exit of the rear panel. The GND screw thread specification is M3X0.5, effective depth of
thread is 5mm.
Step 4
Adjust the lens to the proper angle according to your monitor requirements.
