User’s Manual
14
Sync interface
Table 3-6
Description of sync interface parameters
Parameter
Description
Environment
System Phase
The red square indicates the situation of signal transmission.
Surrounding Signal
The black square indicates the surrounding signal. It’s convenient
to use the mouse to calculate the phase differences between
antenna system and peripherals.
Channel Signal
Noise
Noise of surroundings
Signal
Interference strength of the signal in the surroundings
Surrounding Phase
Click Refresh and the antenna will automatically collect
environmental data and upload the calculated phase value.
Debug Phase
Use the mouse to change the phase value so that the upper right
corner of the red square and that of black square are on the same
line.
Function Key
CH
Select the channel to be debugged.
Refresh
Select the corresponding phase channel and click Refresh. The
antenna will collect the ambient data and upload it to the system
for synchronization. To facilitate system synchronization, select the
channel with the best signal for configuration. If signal interference
of the channel is very large, choose one of the antennas to reduce
the sensitivity of the hardware (J10) on the RX board, and restore it
to the initial state after the synchronization is over.
AC Freq AC
Select 50 Hz or 60 Hz according to the local power supply voltage
Summary of Contents for DHI-ISC-EAA6000-P
Page 28: ......
